|Company Name||Keenpower Electronic Limited|
|Country/Region:||Guang Dong - China|
|Last Online:||23 Aug, 2018|
remote control pet training collar with lcd display,Multi-dog Training System pet accessory
Remaining Shelf Life:>6 months
Usage:Training & Behaviour Aids
Applicable Dog Breed:Universal
Dog snacks Type:Chewing Gum
Mode:sound, vibration and static shock
Training Products Type:Agility Training Products
Place of Origin:Guangdong, China (Mainland)
Press Mode button to choice the different mode(sound, vibration and static shock) and press the UP/Down button on right hand side to set level.
Press M1 button to choice the memory group
Adjust the right levels for each mode and press M2 to set the memory
There are 3 memory groups for each channel
Power Saving function for the transmitter and receiver
The transmitter will go into STANDBY MODE if not operated for 2 minutes (the LCD screen is off) and will TURN OFF if not operated for 5 minutes.
In STANDBY MODE, press mode button to wake it up.
To TURN ON the transmitter, hold mode button at least 3 seconds.
The receiver will turn into sleep mode if it is unused for 4 minutes.
Any movement will activate the receiver into the working mode
Mistake Prevention function
To prevent your pet from the mistake operation, this system set the working time up to 10 seconds.
each time. Then you have to repress the launch button again to keep operating.
Connect your transmitter with your receivers:
Before using this system, please connect your transmitter with your receivers.
Install the battery(1x6F22/9V) in the transmitter and ensure the polarity is correct.
Adjust the channel button to the right one you want to stay.
Install the batteries(2xAAA 1.5V) in the receiver(please refer to how to install the batteries in receivers)
There is a beep right after installing the batteries.
After hearing the beep, you should press the launch button from the transmitter to encode the transmitter and the receiver immediately. There is a beep again from the receiver if you encode successfully.
If there is no response from the receiver, reinstall the batteries from the receiver and press launch button again.
This system could train up to 3 dogs at the same time. To encode different dogs, just change to different channel and repeat the procedure as described again.
Introduction for the transmitter:
There are 7 buttons in the the transitter.
Channel button( up to 3 channels)
Mode button (sound, vibration and shock)
M1 memory group button(up to 3 memories)
M2 memory set button
Level buttons (Up and Down)
To install the batteries, open the battery cover at the back of the transmitter.
Install the battery (1 x6F22/9V) - ensure the polarity is correct.
The transmitter will be TURN ON automatically.
Notes:These three modes could be combined freely, so please set those modes,you don't want at the level 0.
2 X Receiver
1 X Remote control unit.
1 X Testing LED((Clips to collar and lights up to tell you the shock action is operating))
2 X black nylon strap collar (collar length adjustable from 20 to 50 cm and width 2 cm).
1 X 9V 6F22 battery (use for remote control)
4 X 1.5V AAA battery (use for receiver)
4 X 15mm shock electrodes(use for Long Hair)
4 X 10mm shock electrodes (use for Short hair)
1 X User manual